C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
-
Remove the protective cap from the bleed nipple.
-
Connect the collecting bottle hose. Open the nipple approximately one turn.
-
Press in the caliper's pistons at the bottom of the caliper. Use tool 999 2809 PRESS TOOL See: Tools and Equipment/999 2809 Press Tool 9 (2
x). Leave the tools on the caliper.
-
Depress the brake pedal to the limit position and keep there for approximately 2 seconds before releasing. Repeat this until 2-3 dl brake fluid has
been drained.
-
Close the bleed nipple when the brake pedal has been depressed to the limit position.
-
Remove the hose and install the protective cap.
Remove:
-
The tools from the brake caliper.
Installing brake pads, left rear
-
Install the brake pads, see Brake pads rear, replacement See: Disc Brake System/Brake Pad/Service and Repair/Removal and
Replacement/Brake Pads Rear, Replacement
-
Depress the brake pedal a few times.
Changing the brake fluid, right rear
Repeat the procedure, according to points.
Finishing work
