C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Condenser HVAC: Procedures
Cleaning the condenser/evaporator
Special tools:
115 9611 SPRAY See: Tools and Equipment/115 9611 Spray
116 1454 ODOR TREATMENT See: Tools and Equipment/116 1454 Odor Treatment
General and equipment
The air conditioning (A/C) system evaporator has a surface coating which can cause a concrete-like odor. The odor can be treated with an agent that is
sprayed on to the evaporator.
Equipment for treating evaporator
-
Compressed air spray for liquids, for example, Volvo's rust inhibitor spray P/N 115 9611 SPRAY See: Tools and Equipment/115 9611 Spray.
-
Protective goggles.
-
Rags.
-
Vacuum cleaner.
Materials
-
Air conditioning (A/C) odor treatment (liquid), P/N 116 1454 ODOR TREATMENT See: Tools and Equipment/116 1454 Odor Treatment.
Warning! Read warning text on pack before commencing work. Use protective goggles and gloves when spraying. Seal hole around the spray
nozzle with rags during spraying to avoid spray mist leaking out into the car interior. Ensure that ventilation is good.
Preparations for spraying
Opening the evaporator drainage
-
Check and correct if necessary that the drainage from the evaporator is not blocked.
-
Place a container below the evaporator drainage pipe in order to avoid spillage on the floor.
Warming up the evaporator
-
Select recirculation, set temperature control to max. heat and blower selector to max. speed. All vents should be fully open.
-
Shut off the air conditioning (A/C) compressor by disconnecting the cable terminals from the pressure switch (Pressostat) in the engine
compartment. (The compressor can be overridden if the air distribution selector is in the Defrost position and may therefore start up.)
