C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Driver/Vehicle Information Display: Description and Operation
Diagnostic functions
Reading and Erasing Diagnostic Trouble Codes (DTCs)
Stored diagnostic trouble codes (DTCs) can be read off and erased using this function. The on-board diagnostic (OBD) system can identify 16 faults
through diagnostic trouble codes (DTCs).
Description Of Scrolling Values
Fuel level, value
Measurement range 0 - 70 liters (0 - 18.5 US gallon). The control module derives fuel volume from the signal from the fuel level sensor.
Engine coolant temperature, value
Measurement range -40 to +215 degrees C (419 degrees F). The control module further receives information about engine coolant temperature (ECT)
from the engine control module (ECM).
Engine speed (RPM), value
Measurement range 0 - 8000 rpm. The control module receives information about engine speed (RPM) from the engine control module (ECM).
Fuel consumption, value
Measurement range 0 - 23.59 liters per hour (0 - 6.23 US gallons). The parameter is supplied in consumption per hour because the engine fuel
consumption can then be measured when the engine is running but the vehicle speed is zero.
The control module receives information about fuel consumption from the engine control module (ECM).
D+ Charging, status
This value displays if the generator is charging the battery.
YES =
Generator charging.
NO
=
Generator not charging.
Description of control module programming
Mileage, value
Measurement range 0 - 1048575 km or 0 - 651554 miles. The parameter can only be programmed once before the read off mileage exceeds 500 km or
310 miles.
Distance conditions service, value
Indicates the mileage which must be reached in order to light the service reminder indicator (SRI). A number of mileages are available for selection if the
parameter is to be changed.
Time conditions service, value
Indicates the time which must be reached in order to light the service reminder indicator (SRI). A number of alternatives are available for selection if the
parameter is to be changed.
Engine time conditions, value
Indicates the time the engine must have been running in order to light the service reminder indicator (SRI). A number of alternatives are available for
selection if the parameter is to be changed.
Calibration fuel consumption, value
Measurement range -25 to +25%. Indicates current trip computer fuel consumption function calibration. If the trip computer displays too low a value it
can be corrected by selecting a suitable positive value. Too high a value is corrected with a suitable negative value.
Description of activation components/functions
Lamps and needles
The combined instrument panel lamps flashes and the gauge needles sweep from minimum to maximum in 16 seconds.
The following components are activated at the same time:
Gauges
-
Speedometer
