volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Starting/Antitheft - No Start/DTC ECM-720A Set|Page 1484 > < Starting/Antitheft - No Start/DTC ECM-720A Set
Page 2
background image

Please fault trace the vehicle according to SERVICE

SERVICE:

If IMMO fault code IMM-233, -234 or -321 is found then also check the TJ 4523.

1. Inspect the B+ cable at its terminal attachment to the fuse box for corrosion and anything else that could cause voltage loss in the circuit.

2. Check the system relay for fuel system (2/32) P/N 9494448.

3. Check ground points 31/51 and 31/52.

4. Check and remove other keys/transponders near the ignition key that could disturb the transponder signal.

5. Inspect the terminals for fuse (for immo control unit) 11C/8.

6. Make a Immo reset (by either pulling fuse or connector at immo control unit).

7. If no faults been found replace the antenna ring P/N 9442961.

If a problem still exists: continue fault tracing according to VIDA possible faults:

-

ECM or CDM are not programmed.

-

ECM receives an incorrect immo code from antenna ring (see above).

-

ECM or CDM has incorrect immo code (due to swapped units).

-

Defect ECM or CDM (less likely).

CDM = CAN (controller area network) and Driver Interface (Instrument cluster)

VOLVO STANDARD TIME GUIDE OPERATION NUMBER:

36001-2 Diagnostic trouble codes (DTCs) reading/resetting

See VSTG

Starting/Antitheft - No Start/DTC ECM-720A Set|Page 1484 > < Starting/Antitheft - No Start/DTC ECM-720A Set