C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
-
Remove the air baffle between the spoiler and the frame member
-
Disconnect the pipe coupling for the compressor (the suction pipe)
-
Remove the receiver/drier, suction pipe and bracket by lifting it where it is hooked into the side member
-
Remove the receiver/drier and suction pipe from the bracket
When replacing suction pipe:
-
remove the suction pipe from the receiver/dryer.
NOTE: Note the position of the suction pipe relative to the receiver/drier.
Installing receiver/drier or suction pipe
When replacing receiver/drier:
-
first read section Before starting work on the receiver/drier or suction pipe
-
fill the new receiver/drier with new oil.
-
transfer the suction pipe from the old receiver/drier to the new one. Tighten to: 30 Nm.
NOTE: Note the position of the suction pipe relative to the receiver/drier.
When replacing suction pipe:
-
first read section Before starting work on the receiver/drier or suction pipe
-
fill the new suction pipe with new oil.
-
install the suction pipe onto the receiver/dryer. Tighten to: 30 Nm.
NOTE: Install the suction pipe in the same position noted when it was removed.
Installing the receiver/drier or suction pipe, common operations
-
Install the receiver/drier and suction pipe on the bracket
-
Install the receiver/drier and suction pipe with the bracket on the side member
-
Install the quick-release connector for the evaporator at the receiver/drier
-
Install compressor pipe coupling. Tighten to: 25 ±6 Nm
-
Fill the system with refrigerant. Check for leaks
-
Install the air baffle
-
Install fresh air hose on the control module box
-
Install the battery negative lead.