volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Procedures|Page 3687 > < Application and ID|Page 3684
Page 1
background image

Catalytic Converter: Procedures

Replacing The Three-way Catalytic Converter (TWC) 

Special Tools:  999 5543, 999 5972.

NOTE:  As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.

Removing The Three-way Catalytic Converter (TWC) 

-

Applies to B52x4T:  Remove the left front wheel.

-

Disconnect the heated oxygen sensor (HO2S) connectors.

-

Release the heated oxygen sensor (HO2S) wiring from its mountings.

-

Applies only to B52x4T:  Remove the lower rear screw for the heat deflector plate above the turbocharger (TC).

-

Remove the nuts for the front exhaust system connection to the turbocharger/manifold.

-

Remove the SIPS member.

-

Remove the clamp where the exhaust system divides downstream of the three-way catalytic converter (TWC).

-

Lift off the exhaust pipe from the turbocharger (TC)/manifold and the rear system.

-

Lower/draw down the exhaust system.

HINT:  Use a mobile jack with universal plate 999 5972 as support.

Transferring Components 

Procedures|Page 3687 > < Application and ID|Page 3684