C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Engine Control Module: Removal and Replacement
Engine control module (ECM), replacing
Special tools:
999 5722 Wrench See: Tools and Equipment/999 5722 Wrench
Points to observe when replacing the control module
Caution! New software can only be ordered when the control module is installed in the car. VIDA reads off the new control module identity
which is required to order the correct software. The software can only be ordered when the control module is installed in the car.
Caution! Wait 2 minutes after the ignition has been switched off. The main relay must be voltage-free before the control module can be
removed from the car. If the engine cooling fan runs on after the ignition has been switched off, wait until it stops and then wait for another 2
minutes.
Caution! Always check that the control module and control module box connector pins and sleeves are not bent or damaged. This may have
caused the fault.
Removing the control module