C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Install the brake caliper. Use new screws. Tighten to 100 Nm.
Tighten the center screw for the drive shaft. Counterhold the brake disc. Use a screwdriver.
Clean and check that the ABS sensor mating surface on the wheel spindle is true.
Apply a very small amount of grease to the mating surface.
Install the ABS sensor cable in the holder on the spring strut.
Install the ABS sensor. Lubricate the screw and tighten it. Tighten to 10 Nm.
Install the wheel
-
Install the wheel studs lightly. Then tighten crosswise. Tighten to 110 Nm.
