volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Shift Solenoid, A/T|Service and Repair|Page 4239 > < Shift Solenoid, A/T|Service and Repair|Page 4237
Page 9
background image

Install: 

-

the screw for the front engine pad. Tighten to  50 Nm 

-

the holder for the ground lead.

 Applies only to cars with parking heaters: 
Install the heater on the sub-frame.
Install the fuel line for the heater in the holders on the sub-frame.
Install the radiator hose.

Install: 

-

the front splash guard

-

the splash guard under the engine.

Lower the vehicle.
Remove the lifting beams and hooks from the engine
Fill with new oil to the volume previously noted.
Top up and check the oil level. See:.

Note! When replacing the transmission oil, the transmission oil replacement counter must be reset. See:  Transmission fluid, replacing . 

Top up the coolant.
Check any diagnostic trouble codes (DTCs).

Replacing the control system 

Preparations 
Remove. See:  Removing the control system cover.

Shift Solenoid, A/T|Service and Repair|Page 4239 > < Shift Solenoid, A/T|Service and Repair|Page 4237