volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Procedures|Page 4313 > < Procedures|Page 4311
Page 6
background image

-

the large connector and the bracket. Tighten the smaller connector. Tighten to 25 Nm.

Connect the large connector
-

the tie straps for the cable harness

-

the cable on the lever

-

the screws for the bracket. Tighten to 25 Nm.

Installing engine compartment components 

Install the Air Cleaner (ACL) housing, including all hoses and electrical terminals.

Checking diagnostic trouble codes (DTCs) 
Check and erase any Diagnostic Trouble Codes (DTCs).

Transmission Output Speed Sensor, Replacing

Transmission output speed sensor, replacing 

Note:  As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information is always correct.

Preparations 

Procedures|Page 4313 > < Procedures|Page 4311