C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Install the transmission
Use the mobile jack and gearbox fixture to adjust the height and angle. Locate the gearbox on the engine.
Fit the 7 screws. Tighten crosswise by hand. Then tighten crosswise. Torque: 50 Nm .
Note! When tightening the screws, check carefully that the guide bushings locate correctly in their guide holes. Check that the torque converter
cover is in contact with the engine before tightening.
Remove the fixture and the mobile jack from the gearbox.
Installing the torque converter screws
Note! Use new screws, Torx TX50.
Align the torque converter with the carrier plate by turning the engine with the crankshaft pulley nut and turning the torque converter (accessible through
the hole in the cover.)
Install all 6 screws by hand. Tighten so that the screw heads rest against the carrier plate. Now tighten with 35 Nm . Socket Torx TX 50 (early models
TX40 to be changed to TX50).
Note! Remove the socket wrench from the crankshaft.
