C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Install a new lock ring to the joint's inner ring.
Apply grease behind the joint via the shaft hole in the inner ring.
Use grease as specified in Oil, grease etc
Install the new boots on the drive shaft
-
Fasten the drive shaft in a vise.
Install the constant velocity joint on the drive shaft.
-
Ensure that inner ring is straight in the constant velocity joint.
Tap the constant velocity joint using a plastic club.
-
Check that the lock ring sits in its groove.
Fit the boots