C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Transmission Position Switch/Sensor: Service and Repair
Replacing the Gear-Shift Position Sensor
Replacing the gear-shift position sensor
Note: As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information is always correct.
Replacing the gear-shift position sensor
Removing engine compartment components
Ignition off.
Remove:
-
the Air Cleaner (ACL) housing and the intake manifold
-
the battery
-
the battery shelf.
Removing the transmission cable
See: Checking and Adjusting the Gear-Shift Position Sensor
Removing the gear-shift position sensor
Remove:
-
the lever
-
the nut, lock washer and rubber seal from the gear-shift position sensor.
Remove the nut for the cable duct. Lift the cable duct to one side.
Remove the two screws from the gear position sensor.
Carefully lift the sensor off the gear shift linkage rod.
Removing the connector from the transmission
