C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Note: Press the tool down towards the flat surfaces below the thread on the shaft.
Remove the lever. Install adjustment tool 999 5475 on the gear shift linkage rod. Check that the shaft is in the N position. The groove on the tool must
align with the marking on the gear position sensor.
Adjusting the gear-shift position sensor
Remove the nut for the cable duct. Lift the cable duct away from the screw. Slacken off the screws for the gear-shift position sensor.
Rotate the gear position sensor so that the mark on the switch aligns with the groove on the tool.
Tighten the screws for the sensor. Tighten to 25 Nm.
Remove the adjustment tool.
Installing the cable duct
Install the cable duct on the screw. Tighten to 25 Nm.
Install the lever on the control shaft. Tighten to 16 Nm.
