S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Ultrasonic Sensor: Removal and Replacement
Ultrasonic sensor and cable harness
Note! The ultrasonic sensor is integrated in the cable harness. In event of damage to the sensor or the cable harness, both the ultrasonic sensor
and the cable harness must be replaced.
Removing the ultrasonic sensor and the cable harness
Remove:
-
the battery negative lead according to Note when disconnecting and connecting the battery lead See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery, Disconnecting
-
the passenger side soundproofing according to Passenger side soundproofing See: Body and Frame/Sound Proofing / Insulation/Service and
Repair/Passenger Side Soundproofing
-
the lower A-post panel on the passenger side according to Lower A-post panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service
and Repair/Removal and Replacement/Lower A-Post Panel
-
the upper A-post panel on the passenger side according to Upper A-post panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service
and Repair/Removal and Replacement/Upper A-Post Panel
-
the cable harness connector (blue) from the control module
-
the cable harness from the A-post
-
the headlining according to:
-
S40 Headlining See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair
-
V40 Headlining See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair.
-
catch (A)
-
the ultrasonic sensor from the casing (B)
-
the cable harness carefully from the headlining.
Installing ultrasonic sensor and cable harness