S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Trunk / Liftgate Lock Cylinder: Service and Repair
Tailgate Lock Cylinder
Tailgate lock cylinder
Removing the tailgate lock cylinder
Remove:
-
the panel according to Tailgate panel See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim Panel/Service and Repair
-
the control by the lock by pressing the pin out
-
the control rod for the central locking motor from the clips
-
the four nuts
-
the outer cover strip
-
the lock cylinder assembly.
Note! The lock cylinder (key section) is not replaceable but is supplied as one component.
Installing the tailgate lock cylinder
Install:
-
the lock cylinder
-
the outer cover strip
-
the four nuts. Tighten to 5 Nm
-
the control rod. Press the pin in
-
the control rod for the central locking motor.
Check the function.
Note! Adjusting the control rod: remove the control rod by the lock. Press the lock cylinder as far to the right as possible so that the control rod
can be pulled out as far as possible. Install the control rod on the lock.
Install the panel according to Tailgate panel See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim Panel/Service and Repair.
