S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
-
Slide the motor on the shaft as close to the end position as possible.
-
Route the wiring through the lower side of the frame. Press the connector in the frame. Connect the connector.
-
Install the wiring. Secure the wiring using a tie strap.
-
Secure the disconnected connector. Use a tie strap. Secure the cable harness in the frame.
-
Install the shaft (use the motor to turn the shaft slightly, if necessary). Position the motor. Install the washer (3) and a new mounting screw.
