S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Position the nut (4) on the shaft. Tighten to 10 Nm.
-
Securely hook the spring (1) from the motor.
-
Position the plastic frame on the lower side of the frame. Mark the section to be removed (1).
-
Cut off the marked area. Use a knife. Check to see if the frame is exposed Correct if necessary.
-
Press the plastic frame into the correct position.
-
Pull down the upholstery. Securely hook the 2 springs (3) in the middle.
-
Then pull down the upholstery further. Pull the upholstery down over the lower side of the plastic panel.
-
Pull the upholstery down to the correct position on the underside. Close the zip fastener (2).