S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Check that the adjuster remains flat. Apply sealing putty if necessary.
Use body putty to seal the openings. Apply and spread the sealing putty correctly.
Apply the original paint colour after the sealing putty has hardened.
Rubber seal, check before installing
Remove the rubber seal from the tailgate/trunk lid opening.
Check:
-
that there are traces of sealing putty along the entire rubber seal, which indicates proper installation
-
the rubber seal for damage (replace if necessary)
-
that the air valves are open.
Caution! If the rubber seal is to be reused, the sealing putty must be applied to the body seam to ensure that the seam is properly sealed. Use
weatherstrip, P/N 1161616. Position the weatherstrip on the body edge.
Check that the rubber seal is not open anywhere in the seam. Press the seam together if necessary.
Install the rubber seal following New rubber seal, installation.
New rubber seal, installation
