S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Remove:
-
the clamp from the vacuum pipe at the side member
-
the vacuum pipe.
Note!
The vacuum pipe must be bent before it can be removed. This vacuum pipe will not be re-used.
Clean the vacuum pipe and pump assembly screw positions. Apply rust proofing agent P/N 1161480.
Install:
-
the front fender liner
-
the left front wheel.
8.
Removing the connector bracket from the transmission (to lower the position of the connectors)
Remove:
-
the shifting cable out off the clip (1)
-
the clip (1) from the bracket
-
the upper tie strap (2) from the cable harness
-
the two mounting screws
-
the connectors by lifting the catches (3) and slide it from the bracket. Note the position of the connectors on the bracket
-
the bracket and remove at the side the cable harness.
9.
Installing the new connector bracket on the transmission
