S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Remove:
-
the connection from the brake servo
-
the bolt and clamp from the vacuum hose (will be re-used)
-
the protective cover for the throttle housing
-
the vacuum hose from the intake manifold by pressing in the locking ring (1) while pulling the vacuum hose out
-
the quick-release connector for the vacuum hose to the additional vacuum pump
-
the vacuum hose. This will not be re-used
-
the bolt (2) from the vacuum pipe on the side member.
4.
Installing the protective sleeve for the throttle cable
Remove:
-
the protective cover from the connector bracket fire wall
-
the throttle cable out from the clip (1).
Install:
-
the protective sleeve (2) over the throttle cable. Slide the protective sleeve as far as possible towards the firewall.
-
the throttle cable in the clip (1).
5.
Installing the new vacuum hose
Position the vacuum hose between the intake manifold and the brake servo.