S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
-
Remove the transport protection on the new control module
-
Center the control module on the ABS hydraulic modulator valves before the valves are pushed into place
-
Carefully position the control module
-
Install the six Torx screws in the following two stages:
Tighten the screws. Tighten to 3 Nm.
Angle-tighten the screws 90°
Note! The torque must not exceed 8 Nm.
-
Connect the pump motor connector.
Installing the ABS hydraulic modulator and the control module
