S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
-
a new piston cooling valve (2) with a new seal washer. Tighten to 35 Nm
-
the inner timing cover. First press the cover into place over the flange at the top of the coolant pump. Then press the remaining section of the cover
into place over the flange around the pump. Check that the cover is correctly positioned
-
the two screws (1) securing the inner timing cover to the cylinder block
-
the lower belt guard.
Installing the timing belt
Install:
-
the screw securing the inner timing cover to the cylinder head
-
idler pulley. Tighten to 25 Nm
-
the timing belt tensioner. Screw in the center screw by hand. Ensure that the fork on the tensioner centers above the cylinder block rib. Check that
the Allen hole on the eccentric is at "10 O'CLOCK"
-
the vibration damper
-
the timing belt.
