S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Install:
-
a new gasket
-
the intake manifold. Do not forget the crankcase ventilation hose. The hose must be inserted up through the gap between the second and third ducts
-
the screws.
Tighten all the screws starting from the center. Tighten to 20 Nm.
Install and tighten the screws for the support bracket (under the intake manifold).
Installing components
Install:
-
the screw holding the dip stick pipe to the intake manifold
-
the bracket between the intake manifold and the pump
-
the brake servo hose
-
the cable for the knock sensor (KS)
-
the mounting screw for the cable duct in the throttle body (TB)
-
the connectors on the assisted air control valve and throttle position (TP) switch
-
the throttle cable
-
the vacuum hoses on the intake manifold
-
the inlet hose between the mass air flow (MAF) sensor and throttle body (TB)
-
the hose from the assisted air control valve in the inlet hose.
Installing the fuel rail
