S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Crankshaft Main Bearing Seal: Removal and Replacement
Crankshaft seal rear, replacing
Special tools:
999 5112 GEAR SECTOR See: Tools and Equipment/999 5112 Gear Sector
999 5651 Extractor See: Tools and Equipment/999 5651 Extractor
999 1801 STANDARD SHAFT See: Tools and Equipment/999 1801 Standard Shaft
999 5678 Special screw See: Tools and Equipment/999 5678 Special Screw
999 7174 Drift See: Tools and Equipment/999 7174 Drift
951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protractor
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information is always correct.
Removing the flywheel and carrier plate
Remove the gearbox:
-
AW55-50SN see Replacing the transmission, AW55-50/51SN See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and
Repair/Removal and Replacement/Replacing The Transmission.
Remove the flywheel / carrier plate. Use gear sector 999 5112 GEAR SECTOR See: Tools and Equipment/999 5112 Gear Sector as a counterhold
when slackening off the screws.
Removing the seal