S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Use new screws. Lubricate and install all the screws.
Tighten the screws as illustrated.
Tighten the screws in the following order:
1. Tightening torque 20 Nm.
2. Tightening torque 60 Nm.
3. Angle tighten 130°. Use protractor 951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protractor.
Valve depressors and camshafts, installing
Note! When installing a new cylinder head, the valve clearance must be set. See Valve clearance, setting / adjusting See: Cylinder Head
Assembly/Valve Clearance/Adjustments/Valve Clearance, Setting/Adjusting.
Lubricate the valve guide wells.
Install all the tappets.
Note! Make sure that the depressors end up in the same place as before. If needed, replace valve depressors to achieve correct valve clearance.
Lubricate the camshaft bearing seats.
Install the intake camshaft. Make sure that the groove at the back of the camshaft is above an imaginary center line.
Install the exhaust camshaft. Make sure that the groove at the back of the camshaft is below an imaginary center line.
