S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Removing the oil pump
-
Remove the four oil pump screws
-
Remove the oil pump.
Use a groove-cut chisel and carefully break at the stop lugs
-
Clean the gasket face and the mating surfaces.
Installing the oil pump
Install the new oil pump.
-
Install a new gasket
-
Carefully insert the oil pump over the end of the crankshaft.
Note! Do not damage the sealing ring in the oil pump during installation.
-
Install 4 new screws as guides
-
Pull in the oil pump with drift 999 5455 PUNCH See: Tools and Equipment/999 5455 Punch and the crankshaft center nut.
Note! Ensure that the crankshaft does not rotate when drawing in the pump.
-
Tighten the screws crosswise. Tighten to 10 Nm
-
Install the crankshaft timing gear pulley.
Carefully tap alternately around the pulley until end position is reached.
Note! The timing gear pulley can only be in one position on the splines on the end of the crankshaft.
Installing the vibration damper