S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Carefully tap the end of the valve stem to ensure that the valve is correctly located in the seat. Use a plastic, aluminum or brass drift to protect the valve
and the surface of the valve lifter.
The sound made by tapping reveals if the valve is correctly seated.
Installing the camshaft and valve lifter
Install both the valve lifters for the inlet valves at cylinder 1.
Check the notes made earlier. Select new valve lifters if necessary.
Note! Only install two valve lifters. The valve lifters must be placed at the same cylinder.
The valve clearance on a cold engine (approximately 20° C) should be:
Note! The tolerances are less at setting! When checking the valve clearance through the plug hole the tolerances are larger.
Install the intake camshaft. Ensure that the lobes at cylinder 1 point upwards.
Apply a little oil to the cam lobe and the upper side of the valve lifter to facilitate measurement later.
Installing the camshaft press
