S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Blower Motor Switch: Service and Repair
Replacing the blower fan switch
-
Remove the knobs from the heater control; insert a small screwdriver at the rear edge of the control.
-
Remove the cover panel (insert fingers in the opening and pull carefully).
-
Remove the four torx mounting screws.
-
Remove the rear section of the bracket. Press carefully at the edge with a screwdriver.
NOTE: The radio must be pulled forward a few centimeters before the rear section of the bracket can be removed.
-
Remove the screw behind the rear section of the bracket Pull the bracket forward slightly.
-
Disconnect the connectors from the switches.
NOTE: Do not disconnect the radio connectors.
-
Lean the heater controls forwards.
-
Remove the extension piece from the switch pins.
-
Press in the four retaining clips. Remove the switch backwards.
Install in reverse order.