S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Oil Filter: Procedures
Replacing The Oil And Oil Filter
Special Tools: 999 5679
Warning
WARNING: Avoid long term skin contact with oil.
-
Extended and repeated contact with oil can cause skin to dry out. This can result in itchiness, dry skin, eczema and other skin complaints
-
Used oil is more dangerous than new oil
-
Used oil may contain contaminants that are a health risk
-
Avoid skin contact, especially with engine oil
-
Use protective gloves if necessary
-
Avoid oil soaked clothing and rags
-
Wash thoroughly after skin contact with oil, especially before meals
-
Use a skin cream to prevent the skin drying.
Checking engine oil
-
Position the car on a flat surface. Wipe the dipstick before this check.
-
The distance between MAX and MIN on the dipstick corresponds to approximately 1.9 liters.
-
Engine at operating temperature: Wait at least 3 minutes after turning off the engine so that the oil can run back to the oil pan.
-
If the level is at the MIN marking, top up with a maximum of 1 liter.
-
Cold engine: The most accurate measurement is obtained by checking the oil when the engine is cold before it is started.
-
If the level is at the MIN marking, top up with 1.9 liters.
Draining engine oil
-
Remove the drain plug
-
Replace the copper washer
-
Install the drain plug. Tighten the drain plug. Tighten to 35 Nm.
Removing the oil filter
