S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Camshaft Position Sensor: Procedures
Replacing Camshaft Position (CMP) Sensor
Remove:
-
relay cover bracket
-
connector camshaft position sensor from bracket.
Removing camshaft position (CMP) sensor
-
Remove the protective sleeve out of the clamp and open the outer cable protection
-
Route the wiring out the protector
-
Clean surrounding around sensor
-
Remove bolt and move camshaft position (CMP) sensor by turning and take sensor out
-
Take cable out clamp.
NOTE: Note the route of the cable and take it out of the clamp.
Installing camshaft position (CMP) sensor