S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Remove:
-
the screw from the ignition coil ground
-
the camshaft position (CMP) sensor.
Remove:
-
the variable valve timing valve connector
-
the ignition coil connectors.
Place the cable harness to one side.
Unscrew the cable duct from the rear edge of the cylinder head and the throttle body (TB) bracket.
Remove:
-
the connector for the engine coolant temperature sensor
-
the injector connectors.
Place the cable duct and cable harness to one side.
Mark up and remove the ignition coils and ignition cables.
Remove:
-
the rear cover for the camshaft
-
the camshaft position (CMP) sensor housing
-
the trigger wheel
-
the hose for the crankcase ventilation from the camshaft cover.
Installing the lifting beam and the lifting hook
Install the lifting beam and the lifting hook. See Replacing the timing belt See: Engine, Cooling and Exhaust/Engine/Timing Components/Timing
Belt/Service and Repair/Removal and Replacement.
Removing the right-hand engine mounting
Remove the right-hand engine mounting. See Replacing the timing belt See: Engine, Cooling and Exhaust/Engine/Timing Components/Timing
Belt/Service and Repair/Removal and Replacement.
Marking the engine
See Replacing the timing belt See: Engine, Cooling and Exhaust/Engine/Timing Components/Timing Belt/Service and Repair/Removal and
