S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Remove the green/black (GN/SB) cable by pressing down the locking tab (see illustration) using terminal removal tool 951 2636 on the cable terminal
while pulling the cable out of the connector at the same time.
Note!
The green/black (GN/SB) cable must not be cut off.
Connecting the cable for the horn, (affects model year 2001-)
7
Open the secondary lock from the connector on the new cable harness by moving it upwards.
Install the green/black (GN/SB) cable in terminal 6 in the new connector. Gently pull the cable to ensure that it is secured. Close the secondary lock.
Pull the old cables as far out from the cable harness casing as possible. Cut off all the cables except for the green/black (GN/SB) as close to the casing as
possible.
Press the cut-off cables into the casing without damage or sticking other parts. Tape if necessary.
Connecting the cable harness to the contact reel and the SRS
8
control module
