S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
-
Install the screws in the mounting for the bracket
-
Tighten the screws. Tighten to 25 Nm.
The heat shield for the steering gear
Install:
-
the heat shield on the steering gear
-
the rear engine mounting on the transmission. Tighten to 60 Nm.
Front exhaust pipe
Install the front exhaust pipe. Use a new gasket.
Tighten to:
-
Front flange 25 Nm
rear clamp 60 Nm.
Gear selector rod
Applies only to M3P and M5P transmissions
-
Install the gear selector rod on the mounting in the transmission
-
Tighten to 16 Nm.
Front-rear member