S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Install the cap nut for extractor 999 5768.
Lightly grease the locating pin on the extractor.
Use a ratchet with an extension and socket.
Press the extractor in against the seal at the same time as the extractor is turned.
Tighten so that the threaded cone screws firmly into the seal.
-
Remove the cap nut from the extractor
-
Install the extractor bracket and nut
-
Remove the seal
-
Check that no seal residue is left.
Lubricate the edges of the new seal using automatic transmission fluid.
Install locating pin 999 5769.
Install the seal on the locating pin. Use drift 999 577 1
Tap in the seal until the drift is against the transmission.
Remove the locating pin.
Check the oil level according to Checking and adjusting the oil.
Install the drive shaft according to Drive shaft right-hand side replacing.
Install the central front-rear member and cross stay.
(Applies only to USA) Install the central front rear member and cross stay.
Replacing the Sealing Ring For the Oil Pump
Replacing the sealing ring for the oil pump
Special tools 999 5069, 999 5117
Note: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information is always correct.
Removing
Removing the transmission
Remove the transmission according to Replacing the transmission.
Removing the torque converter
Pull the torque converter straight out of the transmission. Check the torque converter throat for damage.
Removing the sealing ring from the oil pump
Use extractor 999 5069.
Installation
