S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Removing the cable harness
Note the position of the connectors.
Remove:
-
the connectors for the solenoid valves
-
the screw for the oil temperature sensor holder. Remove the oil temperature sensor from the control system
-
the cable harness from the holders on the control system.
Remove the cable harness.
Installation
Installing the cable harness
Lubricate the O-rings for the cable harness grommet and the oil temperature sensor with automatic transmission fluid.
Install the cable harness. Connect the connectors to the solenoids according to the notes.
Install the oil temperature sensor with the holder and the screw. Tighten to 10 Nm.
Install the cable harness on the holder. Check that the cable harness is correctly positioned.
Sealing the cover