S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Check that the mating surface for the cover is level.
Wipe the cleaned mating surfaces on the cover and transmission. Use denatured alcohol.
Note! Ensure that no dirt gets into the transmission.
Apply a bead of sealing compound, approximately 3 mm thick, to the cover. P/N 1161409-6. Apply the compound around the screw holes.
Installing the cover
Install:
-
the control system cover on the transmission.
Tighten the screws (Torx TX40) alternately.
Tighten to: 12 Nm
-
the oil pipe on the transmission with a new O-ring. Apply a little petroleum jelly to the O-ring.
Tighten to: 10 Nm
-
the oil return line on the control system cover. Tighten the cap nut from above
-
the screw for the pipe holder on the cover.
Tighten to: 10 Nm
-
the splash guards under the engine
-
the splash guard under the left wheel arch.
Lower the car.
Installing the cable harness
