S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Remove the clamps from the inner boot.
Cut the boot and remove it from the shaft.
Cleaning and greasing
Note! The inner constant velocity joint can be cleaned while assembled and blown clean.
Note! If the joint needs to be disassembled and inspected, see Replacing the drive shaft boot on the transmission side See: Replacing The Drive
Shaft Boot On The Transmission Side.
Lubricate the constant velocity joint thoroughly.
The inner constant velocity joint requires 120 g of grease. Apply half the amount of the grease package. The remainder will be used later in the boot.
Installing the boot
