S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
Venting is carried out to remove any over pressure in the boot.
Use a rounded screwdriver. Carefully insert the screwdriver between the drive shaft and boot. Ensure that the boot is in position on the drive shaft.
Ensure that the boot is aligned against the inner rib on the drive shaft.
Install a new clamp. Use pliers 951 2619 Pliers See: Tools and Equipment/951 2619 Pliers.
The drive shaft and vibration damper
Clean off any grease and dirt from the drive shaft. Install the vibration damper following the measurement made earlier.
Hint: To enable the vibration damper to slide more easily, apply a soap solution to the shaft and hole in the vibration damper.
Install new clamps.
