S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
-
Install the 3 studs as shown in the above figure. Turn the short thread length towards the crankshaft.
-
Install the flywheel.
NOTE: Check that the locating pin on the crankshaft is positioned opposite the hole in the flywheel. There is a marking to show the position of
the guide hole.
-
Align gear sector 999 5112.
-
Pull the flywheel towards the crankshaft with the three nuts on special tool 999 5678.
-
The turned section of the nut must be turned towards the flywheel.
NOTE: It is important that the flywheel bears on the crankshaft flange before the other screws are installed.
-
Install the other screws. Use new screws. Tighten the screws crosswise to 45 Nm.
-
Remove special tool 999 5678. Install three new screws. Tighten the screws to 45 Nm.
-
Angle-tighten all the screws crosswise to 65 degrees.
-
Install the engine speed (RPM) sensor assembly with the bracket. Tighten the screws to 10 Nm.
Reinstall the transmission
NOTE: Install the transmission from turbocharged engines.
Test driving and checking
