S40 L4-1.9L Turbo VIN 29 B4204T3 (2001)
-
a new gasket for the cover on the control system. Note that the screws are of different lengths (measured in mm).
Tighten the screws alternately to light contact. Then tighten alternately. Tighten to 10 Nm.
Finishing
Install the cable harness. Connect the connectors to the solenoids.
Install the oil temperature sensor with the holder and the screw. Note that the length of the screw is given in mm. Tighten to 10 Nm.
Install the cable harness on the holder. Check that the cable harness is correctly positioned.
Reinstall according to Replacing the cable harness for the control system, AW55-50/51SN See: Automatic Transmission/Transaxle/Wiring
Harness/Service and Repair.
