S40 L5-2.5L Turbo VIN 68 B5254T3 (2005)
-
Fit the Parking Assistance Module (PAM) on the right-hand side of the cargo compartment beside the rear lamp.
Applies to the V50
-
Screw the control module in with the existing screws with plastic nuts (1) from the kit.
Applies to the S40
-
Apply small pieces of butyl tape by the holes where the control module is to be installed. This will prevent rattling.
-
Secure the control module in the existing holes. Use the clips (2) from the kit.
Connecting to the Parking Assistance Module (PAM)
Illustration A
Connect:
-
black connector to the control module's upper port.
-
brown connector to the control module's lower port.
-
green connector to the car's CAN cable, which has a green connector clamped in the front edge of the large hole in the side of the body.
Illustration B
