S40 L5-2.5L Turbo VIN 68 B5254T3 (2005)
Note: Note: Make sure that the lifters are in the same position as before.
Lubricate the valve tappet wells. Fit all valve lifters. Lubricate the camshaft's bearing seatings. Position the intake camshaft. Make sure that the groove
at the rear edge of the camshaft lies above an imaginary centre line. Position the exhaust camshaft. Make sure that the groove at the rear edge of the
camshaft lies above an imaginary centre line.
Applying liquid gasket
Caution: Ensure that no liquid gasket gets into the oil ducts.
Wipe the film of oil from the contact faces on the camshaft cover and cylinder head. Fit new O-rings around the spark plug wells by the cylinder head.
Apply liquid gasket 116 1059 on the camshaft cover. Use roller 951 2767. The surfaces must be completely covered without any surplus.
Installing the camshaft covers
Lubricate the camshaft cams, the camshaft's bearing surfaces and the top of the valve lifters. Fit the camshaft cover. Position the press tool. Use: 999
5454. Crosswise tighten the camshaft cover parallel to the cylinder head with the press tool. Fit all the screws and tighten from the middle out to the
edges. Tighten according to: Tightening torque. Remove the press tool.
Fit the front engine bracket
Install:
