S40 T5 L5-2.5L Turbo VIN 68 B5254T3 (2006)
Camshaft Position Sensor: Description and Operation
Camshaft Position (CMP) Sensor
The function of the camshaft position (CMP) sensor is to detect the flanks of the camshaft rotor. The signal from the sensor is used by the engine control
module (ECM) to determine the angle of the camshaft.
Each camshaft has four segments per camshaft revolution. A pulse wheel on the camshaft consisting of four teeth (the teeth are positioned by each flank)
is used by the camshaft position sensor (CMP) to detect the segments.
The teeth on the camshaft gear wheel are not equally wide. This allows the control module to determine which flank is detected and therefore which
operating cycle the camshaft is in. When the operating cycle of the camshaft is established, the control module is able to determine which cylinder should
be ignited. In the event of misfire or knock in the engine, the control module is also able to determine which cylinder misfiring or knocking. See also,
Knock sensor (KS) and Engine speed (RPM) sensor Data about the position of the camshaft is used during camshaft control (CVVT).
The sensor, which is a magnetic resistor with a permanent magnet, is grounded in the control module and supplied with 5 V from the control module.
When one of the teeth on the camshaft pulse wheel passes the camshaft position (CMP) sensor, a signal is transmitted to the control module from the
camshaft position (CMP) sensor. The signal varies between 0 - 5 V and is high when a tooth is in contact with the camshaft position (CMP) sensor and
low when the tooth leaves the camshaft position (CMP) sensor.
The camshaft position (CMP) sensor is positioned at the rear of the engine by the controllable camshaft (CVVT).
The engine control module (ECM) can diagnose the camshaft position (CMP) sensor.
