volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Brake Fluid|Specifications|Page 2730 > < Brake Fluid|Specifications
Page 1
background image

Brake Fluid: Service and Repair

Brake fluid, changing 

Note:  The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct. 

Guidelines and background
Guidelines for brake fluid replacemen

It is recommended that the brake fluid is replaced every 45000 km (30000 miles) or every other year. The fluid must be replaced annually on vehicles
driven in conditions requiring hard and frequent braking, such as alpine driving or driving in tropical climates with high humidity. 

Background

The oil must be replaced because it is hygroscopic (the fluid absorbs water molecules from the air). This absorption of water occurs through the brake
hoses and brake fluid reservoir. These components are rubber and plastic respectively and are not completely sealed against water molecules. An
increased water content in the brake fluid dramatically reduces its boiling point and causes corrosion in the brake system components. This results in
damage to the brake system. Braking performance deteriorates markedly. 

Note:  Use only Volvo Genuine Parts brake fluid designated DOT 4+. Never reuse brake fluid. Always keep the brake fluid sealed in the original
packaging.

Note:  Continually check that there is sufficient brake fluid in the brake fluid reservoir when changing brake fluid. 

Preparatory work

Switch off the ignition. Remove all four wheels. 

Replacement
Changing the brake fluid, front
 

Remove the protective cap from the bleed nipple. Install a plastic hose on the nipple. Open the bleed nipple. Collect the brake fluid in a container.
Press the brake caliper piston to the bottom of the caliper. Use G-clamp as illustrated. Leave the G-clamp in pushed in position.

Alternative 1: 

Brake Fluid|Specifications|Page 2730 > < Brake Fluid|Specifications