S60 L5-2.4L Turbo VIN 54 B5244T5 (2005)
-
Take the cable harness from the kit and connect the black female connector to the socket where the connector for the cable for the towbar was
removed.
-
Plug the remaining black connectors into each other.
-
Route the long cable ends out through the socket at the rear edge of the floor support and up to the ground terminal. Route the longer of the cables
on the rear member's right-hand side, and the shorter to the holder for the main fuses.
-
Take a fuse, two nuts and two washers from the kit and install the fuse in any free terminal.
-
Connect the cable with the small ring cable terminal.
-
Install washers and nuts. Torque tighten the nuts to 5 Nm (4 lbf.ft.).
