S60 L5-2.4L Turbo VIN 54 B5244T5 (2005)
NOTE: Ball holder and ball purchased separately.
-
Remove the cover from the towing member.
-
Insert the ball holder into the towing member until the holes in the ball holder and towing member correspond.
-
Slide the locking bolt into the hole.
-
Lock the other side using the locking pin.
-
Position the ball in the hole on the ball holder.
-
Install washer and nut, torque tighten to 244 Nm (176.5 lbf.ft).
Storing the ball holder
-
Remove the ball holder. Place the ball holder in the supplied storage bag.
-
Place the bag with the ball holder in the spare wheel. The ball holder must be positioned as illustrated.
-
Thread the strap through the two nearest holes in the wheel and around the ball holder.
-
Insert the strap into the tensioner. Tighten the strap until the ball holder is secured.
Installing the protective cover
-
Install the protective cover when the towbar is not in use.
Installing the decal
Illustration A applies to cars without integrated carrier bag holder in the cargo compartment floor