S60 L5-2.4L Turbo VIN 54 B5244T5 (2005)
Installation
Installing the flywheel
Note! Ensure that the mating surfaces on the crankshaft and flywheel are completely clean.
Use: 999 5678 Special screw See: Tools and Equipment/999 5678 Special Screw , which consists of 3 studs with nuts.
Install:
-
3 studs belonging to 999 5678 Special screw See: Tools and Equipment/999 5678 Special Screw , distributed as illustrated
-
the flywheel.
Note! Check that the locating pin on the crankshaft is positioned opposite the hole in the flywheel.
Note! Only applies to cars with dual mass flywheels. There is a marking in the form of a shallow hole (see the arrow). The marking indicates the
direction to the guide hole on the flywheel.
Locate: 999 5112 GEAR SECTOR See: Tools and Equipment/999 5112 Gear Sector against the flywheel.
Alternately tighten the nuts on the flywheel to the crankshaft. Use the three nuts which belong to 999 5678 Special screw See: Tools and Equipment/999
5678 Special Screw.
Caution! The flywheel must lie against the crankshaft flange before the screws are installed. There is a risk that excess locking fluid on the
screws will come between the mating surfaces.
Install 7 new screws. Tighten. See applicable specifications.
Remove the 3 nuts and studs.
Install the remaining 3 new screws for the flywheel. Tighten. See the relevant specifications.
Install the engine speed (RPM) sensor with the bracket. Tighten.
Finishing
To install the clutch, see: Pressure plate/clutch driven plate, replacing, B5244T5, M66 See: Clutch/Clutch Disc/Service and Repair.
To install the transmission, see: Transmission, installing, B5244T5, M66 See: Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/Transmission, Installing.