S60 L5-2.4L VIN 64 B5244S6 (2003)
Install
-
the air preheating hose between the heat deflector plate and the air cleaner (ACL)
-
the engine stabilizer brace between the suspension turrets.
Install
-
the front exhaust pipe on the manifold and three-way catalytic converter (TWC). Use a new gasket and new nuts. Lubricate the threads with paste
116 1408. Tighten the nuts. Tighten to 25 Nm.
Warning! Avoid skin contact with the paste.
-
the rubber mounting for the rear exhaust system
-
the front SIPS member. Tighten to 25 Nm
-
the brake pipe on the plastic holders at the front SIPS member
-
the support bracket between the cylinder block and the manifold and three-way catalytic converter (TWC). Tighten the screws
-
the heat deflector plate above the coolant pipes and hoses
-
the right drive shaft. See Half shaft, right, replacing, B5254T2, M58, B5254T2, M56 See: Transmission and Drivetrain/Drive Axles, Bearings and
Joints/Axle Shaft Assembly/Service and Repair/Half Shaft, Right, Replacing
-
the splash guard under the engine
-
the right front wheel. See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
Check
Test run the engine. Check for any leakage from the exhaust system and manifold.
