S60 L5-2.4L VIN 64 B5244S6 (2003)
Accumulator HVAC: Service and Repair
Accumulator / receiver drier, replacing
Note! Chassis number limit, see below:
S60 with chassis no. from and including 471445, see: Receiver drier, replacing See: Receiver Dryer/Service and Repair/Receiver/Drier,
Replacing.
S80 with chassis no. from and including 409455, see applicable procedure.
V70 manufactured in Sweden (factory code: 1) with chassis no. from and including 506584 and V70 manufactured in Belgium (factory code: 2)
with chassis no. from and including 505663, see applicable procedure.
XC70 with chassis no. from and including 195820 see applicable procedure.
Removal
Removing the drier
Remove the condenser. See Condenser, replacing See: Condenser HVAC/Service and Repair.
Remove:
-
the intermediate pipe according to: Pipe receiver drier, replacing See: Hose/Line HVAC/Service and Repair/Pipe Receiver Drier, Replacing
-
the pipe coupling from the condenser
-
the screw for the bracket
-
the drier / receiver.
Installing the receiver drier
Note! Always use new O-rings lubricated with compressor oil.
Position the receiver / dryer on the bracket and mount the pipe from the condenser.
Thread in the screw for the bracket.
Tighten the screw for the condenser-receiver/dryer's pipe coupling.
Tighten to 10 Nm
Tighten the screw for the bracket.
Tightening torque 25 Nm
Install the condenser according to: Condenser, replacing See: Condenser HVAC/Service and Repair.